• How can I modify my load shedding priority list?
• How can I configure the triggering threshold of my smart load shedder ?
• Why a connected load shedder rather than an energy meter for the consumption part?
• I already have a Home + Control connected installation, what product should I add to measure my solar production and self-consumption?
• In addition to my water heater, which energy-consuming appliance(s) can I activate automatically and how?
• How do I implement my packs?

See all 40 articles

• What are the prerequisites for a photovoltaic production monitoring system in Home + Control ?
• During the installation of my connected contactor or latching relay, can I wire power elements on the C1 and C2 terminals ?
• My home is equipped with push-button switches with dimming. Can I use them with a connected latching relay ?
• My home is already equipped with push-button switches to control lights through a latching relay. Do I need to replace them in order to install a connected latching relay ?
• Do I need a protection on the control circuit when installing a connected contactor ?
• In a retrofit situation, can I pair a connected contactor with an existing standard contactor ?

See all 13 articles

• How can I modify my load shedding priority list?
• How do I configure my modules to monitor my photovoltaic production?
• How can I configure the triggering threshold of my smart load shedder ?
• How to integrate my Ecometer into Apple HomeKit (iOS)
• Why is it mandatory to fill in the tariff and scheduling information even though the TIC (specific French energy tarification transmission) is connected?

• I cannot see products in the rooms during the configuration from the Home + Control App and the guided products installation. What should I do?
• I started the configuration with the Home / Away wireless master switch or the configuration button on my gateway module, but the indicator light on one of the wired products has stayed red or changes to green and then red again. What should I do?
• I installed an Energy Meter in my home but the history of my consumptions is not shown anymore, why ?
• I manually turned off my connected contactor and it is never turned back on, why?
• I cannot see products in the rooms during the configuration from the Home + Control App and the guided products installation. What should I do?
• I have configured an automation that turns on when the grid injection is positive to maximize my solar production, but I still consume on the grid, why?

See all 7 articles

• How do I activate and deactivate the LEDs on my "...with Netatmo" power outlets and switches?
• How do I use smart notifications to be notified when I have energy available?
• What do the light indicators mean on my connected contactor ?
• How does the Peak / Off-peak Hours mode work on my connected contactor?
• Why consumptions measured by the measure module do not appear in Home + Control?
• How to properly set up your solar-based automations based on grid injection and maximize your photovoltaic electricity production

See all 12 articles